/kategori/russian/,2V,2V-12V/each,TXX,Variable,Supply,AC,Output,$109,one,Power,fiwistudio.com,Gear,,DC,Industrial Scientific , Lab Scientific Products , Lab Instruments Equipment TXX DC Variable Power Supply AC each 2V one Output 2V-12V Gear Don't miss the campaign $109 TXX DC Variable Power Supply,AC Output 2V-12V/each 2V one Gear, Industrial Scientific Lab Scientific Products Lab Instruments Equipment /kategori/russian/,2V,2V-12V/each,TXX,Variable,Supply,AC,Output,$109,one,Power,fiwistudio.com,Gear,,DC,Industrial Scientific , Lab Scientific Products , Lab Instruments Equipment $109 TXX DC Variable Power Supply,AC Output 2V-12V/each 2V one Gear, Industrial Scientific Lab Scientific Products Lab Instruments Equipment TXX DC Variable Power Supply AC each 2V one Output 2V-12V Gear Don't miss the campaign

TXX DC Variable Power Supply AC each 2V one Output 2V-12V Gear Don't miss the campaign Free shipping anywhere in the nation

TXX DC Variable Power Supply,AC Output 2V-12V/each 2V one Gear,

$109

TXX DC Variable Power Supply,AC Output 2V-12V/each 2V one Gear,

|||

Product description

Product size: 20*10*17.5cm
Product weight: 2299g
Instructions:
1. Be familiar with the functions of the switches and terminals on the panel before use.
2. Connect the power plug to the 220v.50Hz power supply, turn on the power switch, and the indicator light is on, indicating that the whole machine can work.
3. Connect the load to the required terminal, paying attention to the polarity.
4. When the output is overloaded, it will automatically shut down. After the overload is eliminated, the power supply will resume normal operation.
5. If a large current is connected, it will automatically shut off after 8 seconds of output.
6. After using the instrument, disconnect the power plug from the power source.
Common fault repair:
1. After the instrument is connected to the power supply, the indicator light does not light up. Check whether the plug is reliable, whether the fuse is blown, or the indicator light fails.
2. The output of DC stabilized voltage is very high. Check whether the stabilized voltage integrated block or adjusting resistor is invalid or open circuit.
3. If the output current does not reach the rated value or the automatic protection is turned on, check whether each dry reed switch is "
"Suck to death" means that the contact returns to the normally open state.
4. The high DC current cannot be turned off automatically. Check whether the delay capacitor and transistor are missing.

TXX DC Variable Power Supply,AC Output 2V-12V/each 2V one Gear,